Test pics

[boilerrat]

Test pic

[boilerrat]

Woohoo it worked. In the pic is a mock-up tranny and I have changed the intake already. The airgap was too tall. For most of the new builders on here, the chassis I have is the light comp chassis LS made. I don't have the 4\" drop pans like the rest of you. You can see the clutch fork extension though. I will try to post more pics soon.

[Wendell / Lynn]

Pat, if You want to make the bottom of the car cleaner & not have a piece of angle ready to catch You high centered, notch Your angle trans. support & turn the angle up if I am looking at Your pic correctly?
The drop pans or lack of I think You won't need them anyway, I am 6'2\" & thinking about rasiing my seats a little, I have my windshield more upright than others for plans of a bikini top but Plenty of room & best I remember I am a few inches taller than You? Wendell

[boilerrat]

I did fabricate a new cross member where the angle goes up. I notched out around the tranny mount. I'm 5'9\" except when the keggerator has been hit pretty hard, then I'm 6' even.

[AggieJack]

Lookin' good, Pat. Need more pics as you go.
Lot's of help here if you need us. MOst of us can tel the 3 or 4 ways we tried things B4 we go it to work.

Jack

[Round Rock Cobra]

6' That is funny.

[TexasDoc]

So, the AirGap won't fit?

[Prof]

Did I read that Wendell is wanting to sit higher so folks can see him in his bikini top??? awkward...